EndPointAddressDirectory Prompt Commands (config epad#) |
|
Description |
The EndPointAddressDirectory Prompt is located under the Gateway Prompt. The parameter settings listed here are used to configure specific IP and/or subnet masks that are allowed or are not allowed (barred) to make calls to this Tenor. |
|
Guidelines |
If no IP addresses/subnet masks are specified to be either allowed or barred, then all IP addresses will be allowed to send VoIP calls to this unit, without restrictions. Keep in mind that there is a limit on the number of entries that can be added in the Allowed and Barred lists:
If you choose to use the "Allow" feature, you must include the IP address of this Tenor as one of the allowed IP addresses. This mechanism is in the integrated Gatekeeper, so will only work if the integrated Gatekeeper is in use. If an external Gatekeeper is configured, this mechanism will have no effect, and your external Gatekeeper must be used to restrict access. In order for the EPAD function to work on the Call Relay SP, you must enable inbound ARQ through the var_config.cfg mechanism. Click here for information on how to accomplish that. |
|
Related Topics |
To add a new address to be allowed To add a new address to be barred To change any information for existing Allowed or Barred EndPoints |
|
Location |
VoIP Configuration > End Point Address Directory |
|
Options |
When you click Add above either the Allowed Endpoints or Barred Endpoints table, you must provide an IP address and netmask. Once you have defined allowed or barred Endpoints, the Edit button becomes available to allow you to modify your entry. The Delete button becomes available to remove the entry. |
|
Cmd Type |
Prompt |
|
Prompt Level |
All prompts |
|
Syntax |
config# |
|
Examples |
config-GateKeeperParam-1# show -a |